Instruction ManualWaterproof CasePFL-01For the electronic flashFL-20 Thank you for buying the Underwater Case PFL-01. Please read this instruction m
E-18E-17Open the Case.Insert the buckle opener of the accessory into the buckle openinglever as shown in the figure (in direction ) Pull the buckle op
E-19 E-20Perform the final checks.Visual InspectionAfter sealing the Case, check the sealing part of front and rear lidvisually to confirm that the O-
E-224. Taking photos underwaterSetting the flash modeThis case enables underwater TTL AUTO shooting.Underwater TTL AUTO shootingTurn the case’s mode d
E-24Removing the electronic flashCarefully open the case, loosen theshoe lock dial of the flash and, whileholding the mode dial knob on thecase firmly
E-266. Maintaining the Waterproof FunctionRemove the O-ring.Open the Case and remove the O-ring from the Case.Removal of the O-ring Insert the O-ring
E-28Replace consumable products. The O-ring is a consumable product. Independent of the number oftimes the Case is used, it is recommended that the O
E-30operation parts and perform the advance test and the final test.(5) When not using this case, be sure to take the flash out.Q4 : What cautions mus
E-32and use it after applying a thin coat of the special grease. Excessiveapplication of grease does not improve the waterproof function or thepermiss
E-34After-sale Service● You will receive the Warranty card from your dealer. Please makesure that the dealer's name, the date of purchase, etc. h
E-36Olympus digital camera andElectronic Flash (FL-20)Available modelsDimensionsE-35Specifications❈ We reserve the right to change the external appear
E-2E-1Disclaimer●Unauthorised copying of this manual in part or in full, except for privateuse, is prohibited. Unauthorised reproduction is strictly p
E-4E-3Batteries● To supply power to the electronic flash, we recommend you usetwo LR6 alkaline batteries, two lithium batteries, two Ni-Mnbatteries, t
E-6E-5Handling the Product● Use or storage of the product at the following locations may causedefective operation, defects, trouble, damage, fire, int
E-8E-7Disclaimer⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯E-1Please read the following before using the product ⋯⋯⋯⋯⋯E-1For safe use ⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯E-1Batteries ⋯
E-10E-91. PreparationsCheck the contents of the package.Check that all accessories are in the box.Contact your dealer if accessories should be missing
E-12E-11Preparing the caseBefore shooting, prepare the case as described below.:When not using the diffuser plate, place it on the centerpart on the f
E-14E-132)Connecting the hot shoe cableConnect the hot shoe cable, provided with this case, between theTTL cable connector on the inner side of the ca
E-152. Advance Check of the CaseAdvance test before useThis Case has been the subject of thorough quality control for theparts during the manufacturin
Comentarios a estos manuales